Driving a transverter, participating in the Military Auxiliary Radio System (MARS) or Civil Air Patrol (CAP) are just three examples for which an out-of-band extended transmit modification can be handy. Since “out-of-band extended transmit modification” is awfully long, it’s colloquially referred to as “MARS/CAP Mod”.
The modification procedure is the same for the FT-8800, FT-8800R, FT-7900 and FT-7900R. I will use an FT-8800R to illustrate this article. After this modification is complete, the radios will transmit between 137 MHz – 174 MHz and 420 MHz – 470 MHz.
The mod itself is very easy. It simply consists out of removing a surface mount resistor and power-cycling the radio. The first step is to remove the top cover of the FT-8800. The speaker can be disconnected for more room, but in my case, I didn’t think this was necessary.
The second step is to identify the correct resistor. Be sure to double and triple check that you are removing the correct part. The following picture shows the exact position of the SMD resistor. Click on it to see the super large version.
Once you have identified the resistor, remove it. This can be a bit tricky if you don’t have the right soldering tools. A desoldering tool is certainly helpful, but different people have different ways of performing such tasks. One way is to add a small blob of solder to one side of the part and rely on heat transfer within the tiny part to get both sides loose. Some people just cut the resistor with pliers or a scalpel. The latter option can however damage the PCB and the traces.
After this step is completed, reassemble the radio and apply power. The radio will automatically perform a reset and will be able to transmit.